19

2022

-

10

Use, maintenance and installation of liquid filling machine

Because this filling machine is an automatic machine, the sizes of easy to pull bottles, bottle mats and bottle caps are required to be uniform.


Use, maintenance and installation
1. Because this filling machine is an automatic machine, the sizes of easy to pull bottles, bottle mats and bottle caps are required to be uniform.
2. Before driving, you must turn the machine with the rocker to see if there is any abnormality in its rotation. You can start the machine only after it is confirmed to be normal.
3. When adjusting the machine, the tools shall be used properly. It is strictly forbidden to use too large tools or use too much force to remove parts so as not to damage the machine parts or affect the performance of the machine.
4. Whenever the machine is adjusted, the loosened screws must be tightened, and the machine can only be started after turning the machine with the rocker to check whether its action meets the requirements.
5. The machine must be kept clean. It is strictly forbidden to have oil stains, liquid medicine or glass chips on the machine to avoid damage to the machine. Therefore, it is necessary to:
⑴ During the production of the machine, the liquid medicine or glass chips shall be removed in time.
(2) Before shift handover, each part of the machine surface shall be cleaned once, and clean lubricating oil shall be added to each activity department.
(3) Wipe it once a week, especially the places that are not easy to clean in normal use or blow it with compressed air.
Disinfection and flushing
1. Unscrew the upper and lower fastening screws, remove the liquid injection system for overall disinfection, or disassemble it for disinfection and cleaning respectively.
2. Put the liquid inlet pipe in the cleaning solution and start the machine for cleaning.
3. The 500ml model may have errors in the actual filling, which shall be measured with a measuring cylinder before the formal filling.
4. Needle tube for filling machine, standard 5ml or 10ml syringe for type 10, 20ml glass filler for type 20 and 100ml glass filler for type 100.
Installation precautions
1. After unpacking the machine, first check whether the accompanying technical data are complete and whether the machine is damaged during transportation, so as to solve the problem in time.
2. Install and adjust the feed assembly and discharge assembly according to the outline drawing in this manual.
3. Apply new lubricating oil to each lubricating point.
4. Turn the machine with the rocker to check whether the machine is running in the correct direction (counterclockwise facing the motor spindle). The machine must be grounded.

keyword:

Liquid filling machine

Related news